Technical data

SED2 Operation & Maintenance Manual
32 Siemens Building Technologies, Inc.
Step Action Resulting display
7
Press
to return to P0010.
8
Press to access the parameter values level.
9
Press to restore the value of Commissioning Parameter Filter P0010 to
0 (ready).
10
Press
to confirm and save the value, and to exit from the parameter
values level.
11
Press
until r0000 displays or press
to return to r0000.
12
Press
to revert to the standard motor display (as defined by the
customer).
NOTE: “Busy Signal” — While changing parameters, the BOP can display for a
maximum of 5 seconds. This means that the SED2 is busy with higher-priority activities.
Changing Individual Parameter Digits
To quickly change the value of a parameter, modify the individual digits in the display as follows:
1. Verify that you are at the parameter modification level (See the Setting Parameters with a BOP or
AOP section in this manual).
2. Press
.
The right-most digit starts to flash.
3. Modify the value of this digit with the
and
buttons.
4. Press
again. The next digit starts flashing.
5. Repeat steps 2 through 4 until the required value displays.
6. Press
to exit the parameter modification level.
Resetting SED2 Parameters to Factory Defaults
1. Set Parameter Commissioning Parameter Filter P0010=30 (factory setting).
2. Set Parameter Factory Reset parameter P0970=1 (parameter reset).
3. Press
to restore the factory settings of the SED2.