Operating instructions

SICLOCK

TC400

Connecting 6

6.1 Connecting overview

Note the following requirements for the setup:

• The device may only be connected to 24 VDC power supplies that meet the

requirements of a functional extra-low-voltage with safe isolation (PELV). The

cable cross-section must be chosen to ensure that no damage can result from

a cable overheating in the event of a short-circuit in the SICLOCK TC400. For

cable cross-section, see Connecting the power supply (Section 6.2).

• Avoid extreme environmental conditions as far as possible.

• Protect the device against dust, moisture, heat and severe vibration.

• Do not place the device in direct sunlight.

• Install the device in such a way that it does not present a hazard (e.g. by falling

out).

• Do not cover the vent slots.

• Permitted mounting position (Section 4.4.2).

Caution

Only connect I/O devices that are suitable for industrial use.

Caution

Strictly adhere to the specifications for I/O devices.