Computer Drive Installation Instructions

09.95

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
4–26
SINUMERIK 840C (IA)
4.4.2.1 Keywords
Keywords are words reserved by the system.
The following keywords exist:
S LANGUAGE Language set for NCK and MMC
S LANGUAGE1 Language set for WOP
3)
S LANGUAGE2 Language set for simulation
3)
S LANGUAGE3 Language set for PG function
3)
S LANGUAGE4 Language set for user
3)
S BT_NAME FlexOS name of the operator panel interface
S BT_PARAM Name “”; operation without operator panel
S PROTLEN1 Size of the alarm log in number of messages
S PROTLEN2 Size of the service log in number of messages
S FLUSHLEN1 Maximum number of messages buffered for the alarm log
S FLUSHLEN 2 Maximum number of messages buffered for the service log
S FLUSHTIME Maximum buffering time for messages in milliseconds
S PROTMASK1 Type of messages to be entered in the alarm log
1)
S PROTMASK2 Type of messages to be entered in the service log
S PRIO_PO Display priority of NCK alarms with alarm type “power on”
1)
S PRIO_RE Display priority of NCK alarms with alarm type “reset”
1)
S PRIO_CA Display priority of NCK alarms with alarm type “cancel”
1)
S PRIO_PA Display priority of PLC alarms
1)
S PRIO_PM Display priority of PLC messages
1)
S PRIO_KO Display priority of NCK comments
1)
S SYSFONT Defines the character set in the configuration file of the
master control
2)
S TFORMAT Format in which the times are to be written to the log
4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG
1) Up to SW 2 only
2) SW 4.4 and higher
3) SW 5 and higher