Data Sheet for Product

ManualsBrandsSiemens ManualsACCESS - Core Software - 3SAPSiPass integrated – brochure

Technical Specification Sheet

Rev. 1, July, 1999

Document No. 149-396P25 Page 1 of 4

RRE/RRE4 Remote Reader Electronics

Figure 1. APOGEE Security Technologies’ remote reader

electronics, RRE4 (left) and RRE (right).

Description

Utilization of two stage access control readers with

the ACU2 networked intelligent controller is

accomplished using the RRE series of remote card

reader interfaces.

Two basic versions of the RRE are available, the

standard RRE single card reader controller, and the

RRE4, which provides control for up to four card

readers.

Both versions have facilities to interface keypads,

door alarms and request to exit devices, and provide

5 volt, 12 volt and 24 volt outputs to power card

readers, Request to Exit (REX) devices and door

strikes.

Features

Intelligent remote modules provide flexible and

cost effective reader and keypad interfacing,

status monitoring and control capabilities

All remote reader electronics modules

communicate with ACUs via RS-485 multidrop

ports

Use of remote reader electronic modules on an

ACU does not diminish the capacity to utilize

remote input modules and remote relay modules

Remote Reader Electronics for Single Card

Readers (RRE)

Interfaces virtually any type of card reader

technology to the system, together with Wiegand

emulation keypads

Provides four UL grade AA supervised inputs and

one unsupervised input for tamper alarm

Two local form C relays are provided (SPDT-30

Vdc at 2 A) which can be used for any control

action specified by the system, including door

strike activation

Remote Reader Electronics for Four Card Readers

(RRE4)

Interfaces up to four card readers and keypads

using Wiegand emulation interfaces up to 500

feet from the RRE4

Provides four form C relay outputs (4 SPDT-30

Vdc at 2 A)

Provides eight UL grade AA supervised inputs

and one unsupervised input for tamper alarm

Provides 5 volt, 12 volt and 24 volt power

supplies for readers, REX devices and door

strikes

Summary of content (4 pages)

PAGE 1
Technical Specification Sheet Rev. 1, July, 1999 RRE/RRE4 Remote Reader Electronics Features Figure 1. APOGEE Security Technologies’ remote reader electronics, RRE4 (left) and RRE (right). Description Utilization of two stage access control readers with the ACU2 networked intelligent controller is accomplished using the RRE series of remote card reader interfaces.
PAGE 2
Configurations Reader Architecture The ACU2 offers the flexibility of reader interface electronics installation in three different configurations. The reader electronics can be integrated in the card reader housing, with a membrane keypad and installed directly adjacent to the door. This is called a single stage reader.
PAGE 3
1 SECURE 2 ALARM ALARM SEC0089R1 3 OPEN 4 SHORT Figure 2. Four-State Supervision – All alarm input points of the ACU, RRE and RRE4 are fully supervised using dual end-of-line resistors. Four-state supervision indicates all wiring conditions.
PAGE 4
Ordering Information Table 1. RRE/Remote Reader Electronics Description Product Number Remote reader electronics, no enclosure RRE-0CP Remote reader electronics, with enclosure RRE-1CP Dual remote reader electronics, with enclosure RRE-2CP Enclosure lock (one required per RRE that is to have a lock) RRL Table 2.