Installation Instructions

ManualsBrandsSiemens ManualsACCESS - Core Software - 3SAPSiPass integrated – brochure

Document No. 565-884

November 17, 2006

SiPass Driver

These installation instructions only cover the

connection of the SiPass Driver to the SiPass system.

For hardware installation of the Modular Equipment

Controller, see document number 565-570. For

hardware inst alla tion of the Power Open Processor,

see document number 565-571.

Product Description

The SiPass D

river enables communication between

the APOGEE

Automation System an d the SiPass

system.

Product Nu

mbers

986-83482 A

SiPass Driver, Open

Processor with RS-485

ALN

986-83482 B

SiPass Driver, Open

Processor with Ethernet

ALN

986-83482C SiPass Driver, MEC with

RS-485 ALN, 8DI, 8DO,

8AI, 8AO, point expansion

support, HOA-ready

986-83482 D

SiPass Driver, MEC with

RS-485 ALN, 8DI, 8DO,

8AI, 8AO, point expansion

support, with HOA

986-83482 E

SiPass Driver, MEC with

RS-485 ALN, 8DI, 8DO,

8AI, 8AO, point expansion

support, modem, HOA-ready

986-83482 F

SiPass D

river, MEC with

RS-485 A

LN,8DI,8DO,

8AI, 8AO

, point expansion

suppor

t, modem, with HOA

986-83482G SiPass Driver, MEC with

Ethernet ALN, 8DI, 8DO,

8AI, 8AO, point expansion

support, HOA-ready

986-83482H

SiPass Driver, MEC with

Ethernet ALN, 8DI, 8DO,

8AI, 8AO , point expansion

support, with HOA

986-83482L

SiPass Driver, MEC with

BACnet/IP ALN, 8DI, 8DO,

8AI, 8AO , point expansion

support, HOA-ready

986-83482M

SiPass Driver, MEC with

BACnet/IP ALN, 8DI, 8DO,

8AI, 8AO , point expansion

support, with HOA

986-83482N

SiPass Driv

er, Open

Processor w

ith BACnet/IP

ALN

Accessories

538-670

Trunk Interface II, 115V

538-675

Trunk Interface II, 230V

Warning/Caution Notations

WARNING:

Personal injury/loss of life may occur if you

do not follow the procedures as speciﬁed.

CAUTION:

Equipment damage or loss of data may

occur if you do not follow the procedures

as speciﬁed.

Expected Installation Times

7 minutes.

Required Tools and Materials

• Flat-blade screwdriver (1/8-inch blade width).

tem Number: 565-884, Rev. BA

age 1 of 4

Summary of content (4 pages)

PAGE 1
Installation Instructions Document No. 565-884 November 17, 2006 SiPass Driver These installation instructions only cover the connection of the SiPass Driver to the SiPass system. For hardware installation of the Modular Equipment Controller, see document number 565-570. For hardware installation of the Power Open Processor, see document number 565-571. Product Description The SiPass Driver enables communication between the APOGEE® Automation System and the SiPass system.
PAGE 2
Document No. 565-884 Installation Instructions November 17, 2006 • Wire strippers. • Cabling and connectors. See the Connecting the SiPass Driver to the SiPass System section. CAUTION: Always wear an electro-static discharge wrist strap and discharge accumulated static before touching field panel components. Prerequisites • Driver hardware is installed according to its respective installation instructions. • FLN Termination blocks installed, if any.
PAGE 3
Document No. 565-884 Installation Instructions November 17, 2006 S + DRIVER FLN 1 RS-485 TRUNK CABLE (MAX 4000 ft/1219.2 m; STANDARD 24 AWG LOW CAPACITANCE) GROUND WIRE TO EARTH (P/N 538-583) POWER PACK POWER S + 2 3 7 20 TRUNK INTERFACE II BLN RS-232 PORT (25-PIN FEMALE) RS-232 Cable (P/N 536-004) (MAX 50 ft/15.24 m) SiPass Server PC GW1271R1 3 2 5 4 Figure 1. Table 1. Siemens Building Technologies, Inc. RS-232 PORT 9 PIN MALE Connecting the SiPass Driver to the SiPass System.
PAGE 4
Document No. 565-884 Installation Instructions November 17, 2006 Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners. © 2006 Siemens Building Technologies, Inc. Siemens Building Technologies, Inc. 1000 Deerfield Parkway Buffalo Grove, IL 60089-4513 U.S.A. Your feedback is important to us.