User Manual

ManualsBrandsSiemens ManualsFire - Detectors & PeripheralsSMS-2S / SMS-SA Dual Stage Manual Station / Single Stage Manual Station with Auxiliary Contacts, Installation Instructions

Siemens Building Technologies

Fire Safety

P/N 315-033430C-5

INTRODUCTION The Model SMS-2S/-SA Manual Station from Siemens

Building Technologies, Inc. is an addressable device

containing advanced control panel communication

technology. This technology, which provides two-

direction communication with the control panel,

produces an Intelligent Initiating Device.

PROGRAMMING Refer to Figure 1 to locate the opening on the SMS cover that allows access to the

programming holes which are on the SMS printed

circuit board.

To connect the SMS to the SDPU Programmer/Tester,

insert the plug from the SDPU cable provided with the

Programmer/Tester into the opening on the SMS as

shown in Figure 2. Because SMS devices are polarity

insensitive, the programming plug can be inserted into

the programming holes in either direction.

To prevent potential damage to the SDPU DO NOT

connect an SMS to the SDPU until at least one wire is

removed from terminals 1 or 2 of the SMS.

Follow the instructions in the SDPU Manual (P/N 315-033260C) to program the SMS

to the desired address. Record the device address on the label located on the SMS

front panel. The SMS can now be installed and wired to the system.

OPERATION The SMS manual station operates with the FS-250C Control Panel via the FDLC

Device Loop Card.

The SMS-2S/-SA manual station housing has a pull down lever that locks in position

after releasing a spring loaded switch. (See Figure 4.) To indicate the manual station is

activated, the pull down lever remains down and locked until the station is physically

reset. The SMS-2S/-SA manual station has a set of normally closed auxiliary contacts

which are available for releasing door holders and magnetic door locks.

The SMS-2S has a keyswitch which can activate a second address.

The unit is reset by opening the hinged housing cover with an Allen key and then

closing and locking the cover, or by returning the keyswitch to its original position.

Figure 1

SMS Cover

Dual Stage Manual Station (For Canadian Two-Stage Applications)

Single Stage Manual Station with Auxiliary Contacts

Installation Instructions

Models SMS-2S / SMS-SA

OPENING TO

PROGRAMMING

POINTS

PLUG FROM

SDPU

LOCATING TAB

PROGRAMMING

POINTS

Figure 2

Connecting the SDPU Plug

INSTRUCTIONS

Summary of content (2 pages)

PAGE 1
Installation Instructions Models SMS-2S / SMS-SA Dual Stage Manual Station (For Canadian Two-Stage Applications) Single Stage Manual Station with Auxiliary Contacts INTRODUCTION PROGRAMMING INSTRUCTIONS The Model SMS-2S/-SA Manual Station from Siemens Building Technologies, Inc. is an addressable device containing advanced control panel communication technology. This technology, which provides twodirection communication with the control panel, produces an Intelligent Initiating Device.
PAGE 2
WIRING FDLC LINE 1 1 FDLC LINE 2 2 FDLC LINE 1 FDLC LINE 2 3 PIGTAIL LEADS Figure 3 SMS-2S / SMS-SA Wiring NOTES: 1. Recommended wire sizes: 18 AWG minimum, 14 AWG maximum 2. Wire larger than 14 AWG can damage the connector. TO NEXT ADDRESSABLE DEVICE 3. When using shielded cable without metal raceway or with nonmetallic raceway, the shields should be terminated at the device ground terminal.