Operation Manual

en Operating the appliance
22
¿ Extra drying * Extra drying
An increased temperature during the
final rinse and an extended drying
phase ensure that even plastic parts dry
better. There is a slight increase in the
energy consumption.
ç Hot water * Hot water
The “Hot water” connection is
recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with circulation
line.
The “Hot water” function allows you to
adjust your appliance optimally to
operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water at the hot water
connection) of at least 40 °C and no
more than 60 °C.
This will save energy and time.
A function prerequisite is that both water
connections (hot and cold) are
connected correctly.
1 Operating
the appliance
Operating the appliance
Programme data
The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
conditions and the water hardness set
value •:‹…. Different influencing factors
such as e.g. water temperature or line
pressure may result in deviations.
Aqua sensor Aqua sensor *
* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, “clean” rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.