Operating instructions

syngo Vessel View
227
Visualization
This step is used to get an initial impression of the data
set and, if necessary, remove structures which hide the
view on the structures of interest.
To get an initial impression of the data set, you may
view it in VRT or MIP representation in the Volume Seg-
ment or page through the data set in the MPR Seg-
ments.
Working with the VRT/MIP representation in the Vol-
ume Segment you may typically
• Apply a VRT preset from the VRT Gallery.
• Create his own VRT preset.
• Change the W/C setting with the middle mouse but-
ton.
• Freely rotate the volume.
• Click on the Orientation Cube to quickly set the ori-
entation to desired standard views.
• Blow up the Volume Segment to full screen size.
Working with the MPR Segments you may typically
• Page through the axial, sagittal and coronal views.
• Change the views to any oblique/double-oblique
view.
• Change the W/C setting with the middle mouse but-
ton.
• Blow up one MPR Segment to go to the Volume Seg-
ment.