Operating instructions

228
syngo Vessel View
Working with the Vessel Navigator you may typically
• Change W/C setting with the middle-mouse button.
• Change the Ribbon Viewer width (if less than the
full vessel width or not enough surroundings are
shown).
• Zoom/Pan to display the region of interest.
• Display curves of either the cross-sectional area of
the vessel or a combination of the minimum, maxi-
mum and equivalent diameters along the vessel’s
center line.
• Measure straight distances perpendicular to the ves-
sel (e.g. diameter of the vessel).
• Measure curved distances along the vessel’s center
line.
• Rotate the Ribbon MPR step by step or in cine mode.
• Change the display to MIP Thin.
To remove unwanted structures you may
• Punch out unwanted structures.
• Apply clip planes.