User guide

User programming via the keypad
7
User Menus
35
Siemens AB
A6V10271018
Security Products
26.09.2011
 The keypad displays UPDATED once the setting has been saved
Reported events
To select events for SMS notification:
1. Scroll to SMS EVENTS and press SELECT.
2. Select EDIT NUMBER and press SELECT.
3. Scroll to the appropriate enabled number and press SELECT.
4. Scroll to REPORTED EVENTS and press SELECT.
5. Scroll to the desired event notification.
 Events selected are displayed preceded by an asterisk.
6. Press BACK to exit.
7.1.10.3 SMS Commands
Once the SMS setup and configuration is complete, SMS features may be
activated. Commands, depending on SMS configuration are sent using a code or
caller ID. The type of code depends on what is set for SMS Authentication. See
page.
The table below provides all available SMS commands. Subsequent action and
response are also provided.
SMS Commands are sent as texts to the phone number of the SIM card on the
controller.
For commands using code, the format of the text is the code followed by either a
space or a full stop. Where **** is the code and “command” is the command:
****.command or **** command.
For example, the command “HELP” is this text: **** HELP or ****.HELP
COMMANDS (**** = code)
Using Code
Using
Caller ID
Action
Response
**** HELP
****.HELP
HELP
All available commands displayed
All available
commands
**** FSET
****.FSET
FSET
Fullset Alarm
Time/date of system
set. If applicable,
responds with open
zones/forceset
zones
**** USET
****.USET
USET
Unset Alarm
System Unset
**** SSTA
****.SSTA
SSTA
Status displayed
Status of system and
applicable areas
**** XA1.ON
****.XA1.ON
Where X10 device is identified as “A1”, it is
triggered on.
Status of “A1”
**** XA1.OFF
Where X10 device is identified as “A1”, it is
triggered off.
Status of “A1”