User Manual
2/17
Building Technologies Division CC1N7808en
Infrastructure & Cities Sector 13.05.2016
Warning notes
To avoid injury to persons, damage to property or the environment, the following
warning notes must be observed!
Do not interfere with or modify the actuators!
All activities (mounting, installation and service work, etc.) must be performed by
qualified staff
Before making any wiring changes in the connection area of the actuators,
completely isolate the equipment from the mains supply (all-polar disconnection).
Ensure that the plant cannot be inadvertently switched on again and that it is
indeed dead. If not observed, there is a risk of electric shock hazard
Ensure protection against electric shock hazard by providing adequate protection
for the connection terminals and by securing the housing cover
Each time work has been carried out (mounting, installation, service work, etc.),
check to ensure that wiring is in an orderly state
Fall or shock can adversely affect the safety functions. Such actuators must not be
put into operation, even if they do not exhibit any damage
Mounting notes
Ensure that the relevant national safety regulations are complied with
Standards and certificates
Applied directives:
Low-voltage directive 2014/35/EC
Electromagnetic compatibility EMC (immunity) 2014/30/EC
Compliance with the regulations of the applied directives is verified by the adherence to
the following standards / regulations:
Automatic electrical controls for household and similar use
Part 1: General requirements
DIN EN 60730-1
Automatic electrical controls for household and similar use
Part 2-14: Particular requirements for electric actuators
DIN EN 60730-2-14
The relevant valid edition of the standards can be found in the declaration of
conformity!
EAC Conformity mark (Eurasian Conformity mark)
ISO 9001:2008
ISO 14001:2004
OHSAS 18001:2007
Disposal notes
The actuator contains electrical and electronic components and must not be disposed
of together with domestic waste.
Local and currently valid legislation must be observed.