User Manual

4/17
Building Technologies Division CC1N7808en
Infrastructure & Cities Sector 13.05.2016
Special versions for fitting potentiometer
Certain types of actuators are supplied ready prepared for fitting a potentiometer.
These actuators differ from the basic type only in that the housing is higher and that
they are prepared for accommodating a potentiometer. Accessories are not required.
The required type of potentiometer is to be ordered as a separate item (refer to
«Ordering»). In that case, the third digit after the dot in the actuator’s type reference will
change from «1» to «2».
Example:
SQN31.111A2700  basic type
SQN31.112A2700  version for fitting a potentiometer
Users have the choice of converting a basic type of actuator to a version for fitting a
potentiometer. For that, a conversion kit type AGA32 is available (refer to «Ordering»).
Attention!
Conversion of the basic type reference must be noted by the user on the actuator’s
type field using a permanent felt-tip pen.
Fitting a
potentiometer
Conversion by the user