User Manual

Troubleshooting en
47
Washing results
Fault Cause troubleshooting
Tableware is not dry. No rinse aid used or dosage
set too low.
1. Add "Rinse aid" →Page26.
2. Set the amount of rinse aid to be
dispensed.
→"Setting the amount of rinse aid",
Page27
Programme or programme
option has no drying phase,
or the drying phase is too
brief.
▶
"Select a programme with drying,
e.g. intensive, strong or ECO pro-
gramme." →Page18
Some option buttons decrease the
drying result, e.g varioSpeed.
Water collects in recesses of
the tableware or cutlery.
▶
Position tableware at an angle
where possible.
The combined detergent
used has a poor drying per-
formance.
1. Use rinse aid to improve drying per-
formance.
2. Use a different combined detergent
with a better drying performance.
Extra Dry not activated to im-
prove drying performance.
▶
Activate Extra Dry.
Tableware removed too
early or drying process not
yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes
after the programme has ended.
Rinse aid used has a limited
drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited ef-
fectiveness.
Appliance door does not
open automatically at the
end of the programme
▶
Adjust the appliance door as de-
scribed in the installation instruc-
tions.
The door gap must be at least
70mm - 100mm.