User's Manual

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
112 Manual, 04/2011, A5E03556174-01
6. Move the '>' cursor to "④": Press or

6\QF
!6:7LPH
6HW&ORFN
7. Confirm "
④": Press OK
LOGO! shows the following display:
2II
6:7LPH
2II
!2Q
The current setting of automatic S/W Time conversion is shown on the bottom row. The
default setting is 'Off': disabled.
To enable/disable automatic S/W Time conversion in parameter assignment mode:
If you want to enable/disable automatic S/W Time conversion in parameter assignment
mode, select "
①" in the parameter assignment menu, then menus "③" and "④". You can
now enable/disable automatic S/W Time conversion.