User's Manual
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
114 Manual, 04/2011, A5E03556174-01
Note
You can specify a time zone difference Δ between 0 and 180 minutes.
The US2 selection is only supported in LOGO! devices as of the series 0BA6.
Let us assume you want to enable European summertime/wintertime conversion:
1. Move the '>' cursor to 'EU': Press
or
2. Confirm 'EU': Press OK
LOGO! shows the following display:
2Qൺ(8
6:7LPH
2II
!2Q
LOGO! indicates that European S/W Time conversion is enabled.
User-defined parameters
If none of the parameters/conversions apply to your country, you can customize these under
menu item '. .'. To do so:
1. Confirm 'On' once again: Press OK
2. Move the '>' cursor to '. .': Press
or
3. Confirm the menu item '. .' : Press OK
The display shows:
00''
˂ PLQ
&XUVRUVROLGVTXDUH
0RQWK00DQG'D\''
6WDUWRIVXPPHUWLPH
(QGRIVXPPHUWLPH
7KHGHVLUHGWLPH]RQHGLIIHUHQFHLQ
>PLQ@
Let us assume you want to configure the following parameters: Start of summertime = 31st
March, end of summertime = 1st November, time difference of 120 minutes.
This is how you can enter your data:
● Press
or to move the solid square/cursor.
● Press
and to change the value at the cursor position.