User's Manual

Programming LOGO!
3.8 Configuring additional functions for LOGO! (0BA7 only)
LOGO!
Manual, 04/2011, A5E03556174-01
125
Changing LOGO! from slave mode to normal mode
LOGO! is now in the following view:


6ODYH
3DVVZRUG
!1RUPDO
1. Move the cursor to "
①": Press or
2. Confirm "
①": Press OK

!1R
<HV
&KDQJHPRGH
3. Move the cursor to "
②": Press or
4. Confirm "
②": Press OK
You have now successfully changed the LOGO! from slave mode to normal mode. LOGO!
restarts automatically and then displays the main menu.
Assigning a password from the LOGO!
1. Repeat steps 1 to 5 as described earlier in the topic "Changing LOGO! from normal mode
to slave mode". LOGO! shows the following display:


6ODYH
!3DVVZRUG
1RUPDO
2. Move the cursor to "
①": Press or
3. Confirm "
①": Press OK
1HZ
1R3DVVZRUG
2OG
4. Enter a password. The procedure is the same as for entering a password for the circuit
program. (see the topic
Password for circuit program protection (Page 91)).