User's Manual

Configuring LOGO!
7.1 Selecting parameter assignment mode
LOGO!
288 Manual, 04/2011, A5E03556174-01
7.1 Selecting parameter assignment mode
Press ESC to change from RUN to parameter assignment mode:

0R
(6&3UHVV
Note
The following applies to earlier device versions up to 0BA2: you open parameter assignment
mode by pressing ESC+OK.
LOGO! changes to parameter assignment mode and opens the parameter assignment
menu:
ႣႭ






%$
%$
3UJ1DPH
!1HWZRUN
'LDJQRVWLF
6HW3DUDP
6HW
!6WRS
Description of the four menu items of the parameter assignment menu
● Menu command ①
You select this command to stop your circuit program and thus change to the main menu of
programming mode. To do so:
1. To move the '>' cursor to "
①": Press or
2. To confirm "
①"': Press OK

!1R
<HV
6WRS3UJ
3. To move the '>' cursor to "
⑦": Press or
4. To confirm "
⑦": Press OK