User Manual

Application Guide

No 1c

Living room

Synco

™

& Gamma

Electrical panel installation, no display and operation

Highlight

· Flush mounted room temperature sensor with integrated controller and digital inputs

Room setup

· 1 - AQR2532 Flush-mount room sensor with AQR2570 base module: The AQR measures and con-

trols the room temperature. He sends the control signals to the valve actuator and to the central control

unit RMB795B which calculates the heating/cooling demand from the control signals and forwards the to-

tal demand to the primary controller.

· 2 - AP 562/02 Valve actuator: The AP 562/02 drives the valve of the radiator. The control signal is sent

by the room temperature controller.

· 3 - UP 258D11, Presence detector: The UP 258 detects the room occupancy and measures the bright-

ness. These data are forwarded to the room thermostat and the combi switching actuator.

· 4 - N 502/02, Combi switching actuator: The N 502 has 8 binary inputs and 8 relay outputs to connect

push buttons and lights. He receives control signals from the presence detector and switches the lights

accordingly.

· 5 - N 523/02, Venetian blind switch: The N 523 is being operated via push buttons or from a central lo-

cation via KNX or IP.