User Manual

Applic

ation Guide

No 3c

Living room

Synco

™

& Gamma

Flush mounting and radio communication

, with display and oper

tion

of temperature

Highlights

· Flush mounting actuators and KNX interfaces

· Central Operation via Synco living central apartment unit

Room setup

· 1 - QAA910, Synco living Room temperature sensor: Measures the room temperature and sends the

data to the central apartment unit.

· 2 - QAX913, Synco living central apartment unit: Central control via radio signal for 12 rooms. It re-

ceives data from the window contacts and and from the room temperature sensors and sends commands

to the radiator control actuators. A heating/cooling demand is automatically sent to the primary controller.

· 3 - SSA955, Synco living Radiator control actuator: Controls the room temperature according to the

commands from the central apartment unit (setpoints, operating mode).

· 4 - UP 258D11, Presence detector: The UP 258 detects the room occupancy and measures the bright-

ness. These data are forwarded to the central apartment unit and to the binary output.

· 5 - UP 510/13, Binary output, 2-fold:

The UP 510 receives control commands from the bus and switches

the lights accordingly.

· 6 - UP 520/13, Shutter actuator: The UP 520 receives control commands from the bus and drives the

blinds accordingly.

· 7, 8 - UP 220/x1, Push button interface: The interface converts signals from conventional push buttons

into KNX telegrams.