User Manual

Application Guide

No 4c

Living room

Synco

™

& Gamma

Flush mounting

display and oper

tion

Highlights

· Flush mounting room temperature sensor with integrated controller and digital inputs

· Flush mounting actuators and KNX interfaces

Room setup

· 1 - AQR2532 Flush-mount room sensor with AQR2570 base module: The AQR measures and con-

trols the room temperature. He sends the control signals to the valve actuator and to the central control

unit RMB795B which calculates the heating/cooling demand from the control signals and forwards the to-

tal demand to the primary controller.

· 2 - AP 562/02 Valve actuator:

The AP 562/02 controls the valve of the radiator. The control signal is sent

by the room temperature controller.

· 3 - UP 258D11, Presence detector: The UP 258 detects the room occupancy and measures the bright-

ness. These data are forwarded to the room thermostat and the combi switching actuator.

· 4 - UP 510/13, Binary output, 2-fold:

The UP 510 receives control commands from the bus and switches

the lights accordingly.

· 5 - UP 520/13, Shutter actuator: The UP 520 receives control commands from the bus and drives the

blinds accordingly.

· 6, 7 - UP 220/x1, Push button interface: The interface converts signals from conventional push buttons

into KNX telegrams.