User Manual

Application Guide

No 5

Floor management station

Syn

™

& Gamma

Central functions for multiple rooms,

floor or the

whole building

Highlights

· Heating/cooling demand collection and forwarding of the total demand to the primary

heating and cooling plant

· Remote operation and monitoring of the rooms and the primary HVAC plant

Building setup

· 1 - QAX913, Synco living central apartment unit: The QAX controls via manual operation or via

individual time programs the room operating modes and the setpoints in up to 12 rooms. The central

operation of lights and blinds is also possible. (only valid for applications 3a to 3c)

· 2 – QAC910, Synco living Meteo sensor: The QAC measures the outside temperature and the air

pressure and sends the values to the central apartment unit QAX via radio signals. (only valid for

applications 3a to 3c)

· 3 – UP 588 Colour toch panel: The UP 588 provides 100 time programs and helps to control and

monitor the rooms or the whole building.

· 4 - AP 257/22, Weather station GPS:

The AP 257 measures the outside temperature, the brightness and

the wind speed and calculates the control commands for the blind actuator.

· 5 - RMB795B, Central control unit: The RMB795B as a room manager provides timeprograms for up to

10 rooms or room groups. It also collects the heating and cooling demands from the rooms and forwards

the total demand to the primary plant or controls it via relay and analog outputs.

· 6 - N 152, IP Control Center: The IPCC with its touch optimised operation and the improved graphic

performance allows a comfortable remote monitoring and operation of the rooms.

· 7 - OZW772, Web server: The OZW772 allows remote monitoring and operation of the complete HVAC

plant including lighting and shading. Especially when the primary plant is controlled by Synco, the OZW

provides access to all datapoints and parameters.