Service manual

5-14 SPARC Enterprise T1000 Server Service Manual • April 2007
FIGURE 5-10 Installing the Single-Drive Assembly
3. Push the fasteners down to lock the drive assembly into place in the chassis.
4. Redress the cable through the midwall in the chassis.
5. Reconnect the data cable to the data/power connector on the drive (
FIGURE 5-10).
If you have a dual-drive cable installed in your system, connect the DRIVE 0
connector on the cable to the data/power connector at the rear of the drive. Do not
connect the DRIVE 1 connector on the cable to the data/power connector at the rear
of the drive in a single-drive assembly.
6. Perform the procedures described in Chapter 6.
7. Perform the necessary administrative tasks to reconfigure the hard drive.
The procedures that you perform at this point depend on how your data is
configured. You might need to partition the drive, create file systems, or load data
from backups.