Service manual

5-26 SPARC Enterprise T1000 Server Service Manual • April 2007
2. Replace the fan tray assembly and cable.
See Section 5.2, “Replacing the Fan Tray Assembly” on page 5-4.
3. Replace the power supply and cable.
See Section 5.3, “Replacing the Power Supply” on page 5-5.
4. Replace the hard drive and cable.
See Section 5.5, “Replacing a Hard Drive” on page 5-12.
5. Replace the memory DIMMs.
See Section 5.6, “Replacing DIMMs” on page 5-19.
6. Replace the socketed system configuration SEEPROM.
The location of this SEEPROM is shown in Appendix A.
7. Perform the procedures described in Chapter 6.
8. Boot the system and run POST to verify that the system is fully operational.
See Section 3.4, “Running POST” on page 3-22.