Service manual

3-48 SPARC Enterprise T1000 Server Service Manual • April 2007
3.7.3 Enabling Disabled Components
The enablecomponent command enables a disabled component by removing it
from the ASR blacklist.
1. At the sc> prompt, enter the enablecomponent command.
2. After receiving confirmation that the enablecomponent command is complete,
reset the server so that the ASR command takes effect.
3.8 Exercising the System With SunVTS
Sometimes a server exhibits a problem that cannot be isolated definitively to a
particular hardware or software component. In such cases, it might be useful to run
a diagnostic tool that stresses the system by continuously running a comprehensive
battery of tests. Sun provides the SunVTS software for this purpose.
This section describes the tasks necessary to use SunVTS software to exercise your
server:
■ Section 3.8.1, “Checking Whether SunVTS Software Is Installed” on page 3-48
■ Section 3.8.2, “Exercising the System Using SunVTS Software” on page 3-49
3.8.1 Checking Whether SunVTS Software Is Installed
This procedure assumes that the Solaris OS is running on the server, and that you
have access to the Solaris command line.
1. Check for the presence of SunVTS packages using the pkginfo command.
■ If SunVTS software is installed, information about the packages is displayed.
sc> enablecomponent MB/CMP0/CH3/R1/D1
SC Alert:MB/CMP0/CH3/R1/D1 reenabled
sc> reset
% pkginfo -l SUNWvts SUNWvtsr SUNWvtsts SUNWvtsmn