Specifications

TC35i AT Command Set
Confidential / Released
TC35i_ATC_V01.05 Page 206 of 278 04.08.2003
7.18 AT^SMGL List SMS messages from preferred storage
Test command
AT^SMGL=?
Response
See command AT+CMGL
Parameters
See command AT+CMGL
Execute/Write com-
mand
AT^SMGL
[=<stat>]
Response
TA returns messages with status value <stat> from message storage <mem1>
to the TE. The status of the messages is u n c h a n g e d (unread remains un-
read).
Otherwise: See command AT+CMGL
Parameters
See command AT+CMGL
Reference
Siemens
Note
· This command can be used only after the SMS data from the SIM have
been read successfully for the first time. Reading starts after successful SIM
authentication has been performed, and may take up to 30 seconds depend-
ing on the SIM used. While the read process is in progress, an attempt to
use any of the sms read commands will result in "+CME Error: 14" (SIM
busy).
· See Chapter 5.4 for AT+CMGL.
· See also GSM 07.05: AT+CMGL
7.19 AT^SMGR Read SMS message without set to REC READ
Test command
AT^SMGR=?
Response
OK
Execute command
AT^SMGR=
<index>
Parameter
See command AT+CMGR
Reference
GSM 07.05
Note
· The AT^SMGR command is a specific Siemens command with the same
syntax as “AT+CMGR Read SMS message”. The only difference is that the
status “REC_UNREAD” of a short message is not overwritten to
“REC_READ”.
· This command can be used only after the SMS data from the SIM have
been read successfully for the first time. Reading starts after successful SIM
authentication has been performed, and may take up to 30 seconds depend-
ing on the SIM used. While the read process is in progress, an attempt to
use any of the sms read commands will result in "+CME Error: 14" (SIM
busy).
· See Chapter 5.5 for AT+CMGR.