Operation Manual

15
en
Service programme
Duration: approx� 35 minutes
Depending on use, the service button (12)
ashes at certain intervals.
The appliance should be cleaned and
descaled immediately using the service
programme� If the service programme is
not run as instructed, the appliance may
be damaged�
A
Caution!
Follow the instructions for using the
descaling and cleaning agents for each
service programme� Please observe the
safety instructions on the packaging of the
cleaning agent�
Never interrupt the service programme�
Do not drink the liquids�
Never use vinegar, vinegar-based products,
citric acid or citric acid-based products�
Never put descaling tablets or other
descaling agents in the drawer (4)�
Specially developed and suitable
descaling and cleaning tablets are
available from retailers or customer
service (see “Accessories”).
Important: If there is a water lter in the
water tank (16), it must be removed before
starting the service programme� Clean the
brewing unit before starting the service
programme, see chapter “Cleaning the
brewing unit”�
To start the service programme, press and
hold the service button (12) for at least
5 seconds�
Information: The service button (12)
ashes while the programme is running.
LED H lights up�
● Empty the drip tray (8) and reinsert it�
The appliance rinses twice�
LED G lights up�
● Open the drawer (4)�
● Drop a Siemens cleaning tablet into
the drawer (4) and close it�
● Press the start button (10)�
LED D lights up�
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark
and then dissolve 1 Siemens descaling
tablet TZ80002 in it� When using
TZ60002, 2 tablets must be dissolved�
● Press the start button (10)�
The service programme will now run for
approximately 10 minutes�
LED F lights up�
● Place a container with a capacity of at
least 0�5 litres under the milk frother
outlet (6)�
● Pull out the milk frother (6) to open it�
The service programme will now run for
approximately 12 minutes�
LED D lights up�
● Rinse the water tank (16) and rell it
with fresh water up to the max mark�
● Press the start button (10)�
The service programme will now run for
approximately 30 seconds and rinse the
appliance�
LED F lights up�
● Push the milk frother (6) in to close it�
The service programme will now run for
approximately 8 minutes�
LED H lights up�
● Empty the drip tray (8) and reinsert it�
If you are using a lter, reinsert it now.
The appliance has been cleaned, descaled
and is ready for use again�