Operation Manual

5
en
LED display
The various LEDs light up and ash to
indicate the following:
D lights up The water tank is empty and
needs to be relled.
D ashes The water lter is exhausted
and needs to be replaced�
Important: When you rst take
the appliance into operation
this ashing light does not
signify “Change lter” (see
“Setting up the appliance”)
E lights up The bean container is empty
and needs to be relled.
F lights up The steam valve needs to be
opened or closed�
F ashes Depending on the setting,
steam or hot water is coming
out of the milk frother�
G lights up When G is selected using
the “coffee strength” rotary
knob, the symbol lights up
while ground coffee is being
dispensed�
H lights up The drip tray is missing or has
not been inserted correctly�
Insert the drip dray�
H ashes The trays are full� Empty the
trays and reinsert them�
I lights up The brewing unit door is open�
Close the door�
I ashes Remove and clean the brewing
unit�
Controls
Power on/off switch O / I
The power on/off switch O / I (9) is used to
switch the appliance on or to switch it off
completely (power supply off)�
Important: To switch off, use the service
button (12)�
Service button A
When the service button (12) is pressed
briey, the appliance rinses and switches
off. If the service button (12) ashes, the
service programme needs to be run� Press
and hold the service button (12) to start
the service programme� The service button
(12) ashes while the service programme is
running and turns off when the programme
has ended�
Steam button B
Press the steam button (11) to generate
steam for frothing milk�
Start button C
Press the start button (10) to start preparing
a drink� Press again during drink preparation
to stop the dispensing process early�