Owner's manual

27
en
If you wish to change the default degree of
water hardness, or if you have inserted a
water lter, proceed as follows:
1� Turn the rotary
knob (13) to position
2� Press and hold buttons B (11) and
A (12) simultaneously for at least
5 seconds� The set water hardness is
indicated by the number of LEDs that
now light up�
3� Now press the start button (10) repeat
edly until the required water hardness
is indicated, e� g�, for water hardness 3,
LEDs D, E and F will light up�
4� Press and hold the start button (10)
for at least 5 seconds� The set number
of LEDs will light up to indicate that
the selected water hardness has been
saved successfully.
Important: If a water lter is used (see
“Accessories”), proceed as follows, see
“Water lter”.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
water hardness setting is retained�
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off
automatically following the last drink
preparation� A time between 15 minutes and
4 hours can be set� To save power you can
specify a shorter period.
1� Turn the rotary
knob (13) to position
2� Press and hold buttons B (11) and
A (12) simultaneously for at least
5 seconds� The time after which the
appliance should switch off is indicated
by the number of LEDs that now light up.
3� Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the switchoff time:
D = 15 minutes
D and E = 30 minutes
D, E and F = 45 minutes
D, E, F and G = 1 hour
D, E, F, G and H = 2 hours
D, E, F, G, H and I = 4 hours
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected switchoff time has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
switchoff time is retained.
Setting the brewing temperature
The brewing temperature can also be set�
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
B (11) and
A (12) for at least 5 seconds� The set
brewing temperature is indicated by the
number of LEDs that now light up�
3� Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the temperature:
LED
D = low
LED D and E = medium
LED
D, E,and F = high
4� Press and hold the start button (10) for
at least 5 seconds� The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
brewing temperature setting is retained�