Manual
39
en
Brightness
The display 5 brightness can be set from
1 to 10.
● Turn the rotary knob 6 to select the
required setting.
Water hardness
● Turn the rotary knob 6 to select the
required water hardness 1, 2, 3 or 4.
Info: It is important to set the water hard-
ness correctly, so that the appliance indi-
cates accurately when the descaling pro-
gramme should be run. The factory setting
for the water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
● Dip the test strip brie y in water and
check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Water filter
A new water lter 29 must be rinsed before
it can be used.
● To do this, press the water lter 29 rmly
into the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the “max” mark.
● Turn the rotary knob 6 to select start and
press the start button 8.
Place 1 l container under milk frother
Place suction pipe in container ▶ start
● Place a container with a capacity of 1 litre
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8. Water will now
ow through the lter 29 to rinse it.
● Next, empty the container.
The appliance is ready for use again.
Info: Rinsing the lter 29 simultaneously
activates the setting for the “change lter”
display.
You can nd detailed information about the
water lter in the enclosed lter instructions.
The lter 29 is no longer effective when the
Service - change filter display appears, or at
the latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement lters can be obtained from
retailers (TZ70003) or from customer
service (575491).
If no new lter 29 is used, turn the Water
filter setting to no.
Info: If the appliance has not been used
for a prolonged period (for example, when
you are on vacation), the existing lter 29
should be rinsed before the appliance is
used again. To do this, simply dispense a
cup of hot water.
TE809_1DE.indb 39 08.05.2013 12:10:13