Manual

47
en
Descaling
Duration: approx. 30 minutes.
Descale ▶ start
The start button 8 ashes while the differ-
ent descaling processes are running.
The gures on the top right indicate the
progress of the programme.
Important: If there is a water lter 29 in
the water tank 11, it needs to be removed
before the service programme is run.
● Press the à button 3.
Descale ▶ start
● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Place 1 l container under milk frother
Place suction pipe in container ▶ start
● Place a container with 1 litre capacity
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8.
Remove water filter ▶ start
Info: If the water lter 29 is activated, the
display will prompt you to remove the lter
29, then press the start button 8 again.
Add 0.5 l water and descaler ▶ start
● Pour lukewarm water into the empty
water tank 11 up to the “0.5 l” mark and
then dissolve two Siemens descaling
tablets in it.
● Press the start button 8. The descaling
programme will now run for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid ▶ start
Info: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the start button 8 again.
Clean and refill water tank ▶ start
● Rinse the water tank 11 and rell it with
fresh water up to the “max” mark.
● Press the start button 8. The descaling
programme now runs for about 1 minute
and rinses the appliance.
Descaling
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Replace the lter if one is being used. The
appliance is ready for use again.
Important: Wipe down the appliance
using a soft, damp cloth to immediately
remove any descaler residue. Such residue
can cause corrosion. New sponge cloths
may contain salts. Salts can cause rust
lm on stainless steel and must therefore
be washed out thoroughly before use.
Thoroughly clean the suction pipe 10d of
the milk frother.
TE809_1DE.indb 47 08.05.2013 12:10:17