Operating instructions

Building Technologies - 18 - TEL50.GSM
7. Extended configuration
Using the basic configuration already present, the user can customize device parametrization by changing some of the system
parameters via SMS. Carefully note any changes made and keep them with these instructions in order to ensure that the
device is correctly controlled even after a long period of time or by other qualified users.
7.1 Creation of a qualified user list
All the telephone numbers of users (both fixed and mobile), up to a maximum of 20, that have access to the different features of
the device are entered in this section. The numbers entered must have a minimum length of 6 numbers to be considered valid.
If the security parameter is enabled (SECURITY=1) the calls coming from numbers not included in the list will not be accepted.
If there are no configured users or the security parameter is disabled (SECURITY=0), the caller’s number will not be checked.
The telephone number and type of user (see below: configuration valid only for commands sent by SMS) must be entered for
each user. All the users in the list will receive notification of temperature alarms (if a remote temperature sensor is present) and
alarms generated by closure of input IN1.
Users can be entered with three different profiles:
Administrator (extension .1)
This type of user has full control of the device and can therefore insert and remove functional parameters, control and check
states of inputs and outputs and receive notification of alarms and temperature readings.
User (extension .2)
This type of user has partial control of the device and can therefore only control and check states of inputs and outputs, receive
notification of alarms and receive temperature readings. He/she cannot change or query functional parameters.
Notify (extension .3)
This type of user has no control of the device and can therefore only receive notification of alarms.