Network Hardware User Manual

134 U3585-J-Z125-8-76
SET-TASK-PARAMETER Statements for SM2 administrators
TYPE =
The tasks to be monitored are selected via their task attribute. All tasks with the
attributes specified at selection time using the START-MEASUREMENT-PROGRAM or
LOGON command are monitored. If the task attribute of a task is changed in the course
of the monitoring program session, this will not influence the measurement itself, i.e. the
task is neither excluded from nor included in monitoring as a result.
TYPE = *NOT-SPECIFIED
No tasks are selected via the task attribute.
TYPE = list-poss(4): *SYSTEM / *BATCH / *DIALOG / *TP
DEVICES =
Specifies the devices to be monitored by the task monitoring program for each task. A check
is carried out to establish whether these devices are defined in the configuration. It is
possible to monitor up to 64 devices. If more than 64 devices are defined by means of partial
qualification or *DISK, these are selected in the following order of priority:
– devices whose mnemonic device names have been specified in their entirety
– devices whose mnemonic device names have been specified in partially qualified form
– *DISK
With *DISK and *ALL, up to 64 mnemonic names are selected in the order given in the PDT
(Physical Device Table).
DEVICES = *NONE
No devices are to be monitored.
DEVICES = *ALL
All devices are to be monitored, with the exception of communication controllers (CTCCs,
TRANSDATA 960s, 8170 Cluster Controllers, LAN adapters and HNCs).
DEVICES = list-poss(64): *DISK
All disk devices are to be monitored.
DEVICES = list-poss(32): <alphanum-name 2..4 with-wild>
The specified devices are to be monitored. An asterisk (*) is also permitted as the last
character in a wildcard specification.
*SYSTEM:
*BATCH:
*DIALOG:
*TP:
All system tasks are to be monitored.
All batch tasks are to be monitored.
All interactive tasks are to be monitored.
All TP tasks are to be monitored.