Installation Guide

16 © 2015 Siemens Industry, Inc. 813776
 Hang the VersiCharge on the Mounting Bracket
by first hooking the bottom of the unit into the
mounting slot and then hooking the top into the
mounting tab.
 Secure VersiCharge to wall and mounting
bracket using provided screws.
 Ensure that the breaker for the circuit on which
the receptacle is wired is turned to the ‘OFF’
position, plug the VersiCharge into the receptacle
and switch the breaker to the ‘ON’ position.
Rear-fed, Cord-and-Plug Installation
NOTE: Flush mount installations only,
meaning the receptacle is even with wall in
which it is installed.
 Locate a stud within the wall to attach the
mounting bracket.
o For concrete or masonry walls, install
appropriate anchors.
o Verify that the stud or anchor and
surrounding materials can handle the
20+ lbs load of the VersiCharge.
 Ensure that receptacle can be flush mount
installed to the left side of the mounting
bracket.
o Receptacle should be installed prior to
mounting the VersiCharge to the wall.
o NEC® 2014 specifies: Indoor (NEC®
Article 625.29B) states installation 18 –
48 inches above ground level.
o Verify local code with respect to
installation height.
 Wire a standard NEMA 6-50 receptacle
using appropriate wire.