Installation Guide

 Using 7/16 inch socket head and drill, attach the Mounting Bracket to the wall using two

lag screws provided. Verify that lag screws are going into the stud.

 Before starting the step to hang the

VersiCharge unit onto the mounting bracket,

ensure that the circuit breaker on the circuit for

the receptacle is turned to the ‘OFF’ position.

To hang the unit onto the mounting bracket,

place bottom mounting tab into corresponding

slot in mounting bracket. Plug cord into

receptacle. Rotate the unit towards the wall so

that the hook on the unit goes over the top

mounting bracket. Turn the breaker for this

circuit back to the ‘ON’ position to power up

the VersiCharge.

 Secure VersiCharge to wall and mounting

bracket with provided screws

3.4 Hard-wired installation

This section describes the hard-wired installation and the removal of the cord and plug

assembly in case the VersiCharge SG units need to be hard-wired during installation.

Removing the Cord-and-Plug Assembly

DANGER Hazardous voltage. Will cause death or serious injury. Turn off power

before working on this equipment by turning the circuit breaker to which this

circuit is wired to the ‘OFF’ position.

 Open hinged cover by loosening four cover

Phillips closure screws.

 Remove barrier by removing the two securing

screws.

 Remove the cord-and-plug assembly from the

conductor opening

o Disconnect the attachment plug wires from

the terminal block by loosening screws in

position 1, 2, and 3.

o Do not adjust the two screws on top of the

terminal block unit. These are for factory use only.

o Disconnect and remove strain relief and entire cord-and-plug

assembly