Installation Guide

26 © 2015 Siemens Industry, Inc. 813776
 For grounding faults, after 15 minutes, the VersiCharge will attempt to continue charging,
and if no faults are present, will return to the ‘Charging’ state. During this 15 minute
delay, the ‘Fault’ indicator on the unit will blink, the ‘2 Hour Delay’ indicator is illuminated,
and the Halo on the unit will blink red simultaneously.
 If a fault is still present immediately after the VersiCharge re-enters the ‘Charging’ state,
the VersiCharge will return to the ‘Fault’ state, and remain in that state until it is manually
reset. During this time the ‘Fault’ indicator will be illuminated in red, the ‘4 Hour Delay’
indicator will be illuminated, and the Halo on the unit will be illuminated in a constant red
color.
o To reset the device, press the ‘Pause’ button, which will take the device to the ‘Pause’
state.
o Pressing the ‘Pause’ button again will move the VersiCharge to the ‘Ready to Charge’
state, and if a charge is required, the VersiCharge will automatically begin charging
and move to the ‘Charging’ state.
NOTE: To reset the device you can turn the circuit breaker feeding the device ‘OFF’, then
turn it back ‘ON’.
NOTE: Some cars may delay the command to start charging again when coming out of
the ‘Pause” state. Please refer to user manual of the EV if this is happening on your unit.
o If the device continues to experience immediate faults, contact a qualified person for
assistance.
Delay timer LEDs in combination with fault LEDs give more information on fault type.
Please call customer support for more details at 1-800-241-4453.
4.4 Cord Management
The VersiCharge has a built in cord management system.
 When not in use, the coupler cord should be looped over the top of the VersiCharge unit
to prevent accidental damage
 The coupler should be plugged into the coupler holster on the front of the VersiCharge to
prevent accidental damage
 While in use, the cord can be unwrapped, loop by loop, to allow sufficient length of cord
to be unwound to reach the EV receiver
WARNING! Failure to properly protect the coupler and the cord could result in damaged
components, which could prevent the VersiCharge from functioning properly or create a
hazardous situation.
4.5 Delay Timer
The VersiCharge has a built in delay timer to allow users to select the time that they
would like for their EV to charge. The delay timer will prevent the VersiCharge from
entering the ‘Charging’ state for the selected length of time (2/4/6/8 hours).