Installation Guide

Charger status

This tab serves as the primary user interface for remote control of the VersiCharge SG,

with the buttons on the left and right hand side of the screen having identical functionality

as those on the face of the charger (seen below)

 The status screen displays the state in which the charger is operating. Shown above in

the center is the delay state which can be remotely entered by pushing the delay button

once. In this example the ‘charge’ state has been delayed by 2 hours. The graphic above

on the right, shows the ‘Charge’ state. Information about the charge start time and power

in kW is displayed. You have the option to pause and restart the charge from this screen

by using the ‘Pause’ button on the left of the screen.

 Also displayed on this screen is the monthly usage data in kilowatt hours (kWh) which

tracks power consumption and estimates the monthly cost of charging your EV based on

the utiltiy rate information you provided during setup or in the information you enter in the

‘My Charger’ tab.

 Finally, link your account to either Twitter or Facebook to broadcast your EV energy

consumption to your social network.

My account

 This tab allows you to edit the user data entered when

registering for the app and change your password

 You may also unregister your account on this screen, this

should only be done in the case of transfer of charger

ownership

 Finally, use this screen to logout from the application