Installation Guide

My charger

 This tab allows you to control the power level as a

percentage of maximum charge rate (30A). To adjust this

rate, use the + and – buttons that are provided on the tab

and then hit the refresh button shown in the graphic.

 This setting will take into account any adjustment of the

amperage adjustment dial you may have made outlined in

section 3.5.

o For example, if the amperage adjustment dial inside your

VersiCharge unit is set to 100% (factory default), the text in

the app will let you know that the VersiCharge is ‘Charging

the car as quickly as possible’. If you then for example use

this functionality inside the app to set the power level to 50%,

your charging capacity will be limited and the app will let you

know that the ‘Charger is limiting maximum power sent to the

car’. The amount of power the car will draw depends on the

charging capacity of your EV, but the app will also let you

know the ‘Car is drawing XX Amps of the rated 30 Amps’

where the ‘rated Amps’ refers to the setting of your amperage

adjustment dial inside your VersiCharge unit. Lastly, the app

will let you know whether it is connected to the cloud in order

to inform you that the command you have sent is being

transmitted to the VersiCharge unit.

 Also available under the ‘My Charger tab is the utility rate

information. Here you can select which utility rate plan should

be applied to the individual charger in order to accurately

calculate the cost for power being consumed. Not only does

entering the correct information help you accurately view the

cost of charging your EV, but it also allows Siemens to make

recommendations for reducing the total cost of ownership of

your EV.