User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function DPP 2-115
Option=ATCH
Additional text (32 characters) can be placed anywhere in the co-ordinate system. Texts
are numbered from 1..10 and can be deleted or changed at will.
Option=TICH : ATCH
Text
----
Number=. : ?
Number=(1..10), . : 1
1.Text : Information 1
Directn.=Horiz. : ?
Directn.=(Horiz.,Vertical):
Position=Centred : ?
Position=(Centred,L.Justfd):
X-Coordinate[mm]=0 :
X-Coordinate[mm]=0 : 25
Y-Coordinate[mm]=0 : 100
Entry in Graph 3
Number=. :
Operation=GCH :
The finalised entry in a graph is acknowledged with:
"Entry in Graph : n"
("n" = Graph number).
The dialogue is then continued at "Number=.:" level. By entering a number (1..10) a new
text may be entered or an existing one changed.
By entering a full stop at "Number=.:" instead of a number the dialogue continues at
"Operation=GCH" level.
2.12.8 GLI, List Graphic Layout
Operation GLI provides a listing of all generated graphic layouts in three different ways.
A choice of listing can be made from the following:
T8 15:50:53 Function=PNT : DPP
Operation=GCH : GLI
List Mode=LONG : ?
List Mode=(SHRT,LONG,OCT):
For a user a LONG listing is most important.
This provides all information on any graphic layout which has been generated with
Operation GCH.
A listing in SHORT mode provides a summary of any graphic layout which has been
generated with Operation GCH.
A listing in OCT mode gives a graphic layout's generation data in coded form but is
mainly meant for diagnostics.
Continuation of the
dialogue
LONG
SHORT
OCT