User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function DSS 2-139
2.14.1.2 Ctrl/E - Terminate Connection
The connection to a process station (PRV/BPS/EKL-X) may be broken off with Ctrl/E.
This also makes an exit from function DSS.
With input of Ctrl/E an exit is also made from the EKL's own dialogue. If Ctrl/E is
entered during CONF dialogue or in TSK Editor an exit from the operation and a return
to 'Immediate Mode' is made.
Only then can Function DSS be interrupted by a second Ctrl/E.
–
The following message is given after a DSS connection is ended with Ctrl/E:
$177>: ctrl/E
10:19:26 DSS ended to $177
If no active dialogue takes place in DSS after 30 seconds, a 'Timeout' is triggered, which
allows any queued messages to be output on the operating terminal. There is a 'hard'
timeout which, if triggered, automatically breaks off the DSS dialogue:
–
For a PRV/BPS/EKL-X there is a hard timeout after 4.5 minutes.
The following message appears:
10:18:46 dialog-timeout!
10:18:46 DSS ended to $177
2.14.2 List/Print Files
Files which have been saved in the VISONIK Server can be listed on terminals or
printed.
Once in Function DSS listing a file is made with COPY.
Central
Disk
Copy
Disk to Terminal
Terminal
9370Z20
The COPY instruction syntax for listing files from a VISONIK Server on a display or
printer terminal looks as follows:
$xxx> COPY DK:"Name" TO TTx:
where
$xxx> PS address prompt
COPY copy instruction
DK: Source declaration (DK = Server disk)
"Name" File name (has no effect since the file is addressed by the PS point
parameter FILE).
TO copy to
TTx: Report terminal