User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-152 Function GRR Landis & Staefa Division
Example: Group reaction entry
T8 10:34:40 Function=PNT : GRR
Operation =CH : ?
0 CH = Change Data Entry
1 LI = List Data Registers
2 DEL = Delete Register Entry(ies)
3 LSTA = List Reaction Register State
4 LOCT = List Reaction Entries in Octal
Operation =CH :
ctrl/P
T8 10:36:20 Function=PNT : GRR
Operation =CH :
Address Mask =. : ?
Address Mask =., (UA,TA,...,..,*)
UA = AA'AA'A111"dd
TA = $sss'mm'p, $sss'CTYPn, $CTYPn, $sssMxxPyy
... = digitwise range
.. = range
* = all points with UA, $*=all points
: $100'001
Entry =2 : 3
Edge =0&1 : 1
Alternative Dev. =. : .
Extra Device(s) =. : ?
=(&,.,*,+=,
=,STAT,M1,M2,M3,M4,M5,M6,M7,M8,M9,M10,M11,
Blocking Flag=. : .
Reaction =(UA,TA): ?
UA/TA = Change Point Parameter
CT = Printout Cleartext
MC = Issue MACRO Command
SLVM = Output Slave Message
CB = Start/Stop COLBAS Task
. = No Reaction (for MRR & GRR)
PICT = Auto Picture/Point Selection
Reaction =(UA,TA): .
$d100'001 / 3
Edge 1
Reaction .___________No Reaction (for MRR & GRR)
2.16.2 CH, Enter/Change Data
2.16.2.1 Changing an existing GRR entry
In order to change data in a reaction entry it must first be selected via its "reason" and
entry number. If the entry exists, it is listed completely for checking at the operating
terminal.
The edit mode then becomes active, so that the user can modify or confirm each part of
the reaction entry step by step.
A reaction entry is not changed (and re-saved) in the system until every step of this
dialogue has been completed, i.e. after the last prompt for "Message Mask" has been
answered. In all other cases, e.g. if the dialogue is exited with Ctrl/P or Ctrl/E, any
changed data will be lost.
Important: