User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function KEY 2-169
Parameter Level=0: ?
Parameter Level=(0..7), ??: ??
1 1 FL Flag Position
1 1 FLI1 FL Influence 1
1 1 RVAL Resultant Value
1 1 XX Message Language
2 2 PAGE Page Number
2 2 TY Terminal Status
.
.
VISONIK DCS automatically reports any illegal parameter access.
ctrl/P
T1 00:42:46 Function =PNT : a01'b2'ST
ST a01'b2'ST Status OFF
Parameter =ST :
10:56:29 No Parameter Access!
3 3 TERS /Term. Suppressed =NO _
This defines whether the new key can operate on one (Local) VISONIK DCS system or
if access is allowed to several linked (Global) VISONIK DCS systems.
Only a user with a global operating range can give global access to another key.
A VISONIK DCS system can be operated in more than one language. At this point one
of the configured languages can be specified for the named user. At "log-in" the
VISONIK DCS system will automatically switch over to the user's specified language.
Language=0: German
Language=1: First additional language
Language=2: Second additional language
Irrespective of which language is specified in the "KEY" function, once a user is logged
in, changeover to another configured language is possible at any time through Function
XX or with Parameter XX. A language selected in this way remains active even after the
current user logs out.
When the specified named user logs in or out at a VISONIK DCS system a record is
made on the "Extra Device(s)" specified, under the following conditions:
–
A log-out record at an "Extra" terminal can only be made if that terminal is not
occupied by another user.
–
A log-in record at an "Extra" terminal can only made if it is not in dialogue mode and
its operator timeout parameter ATMO<>0. Parameter ATMO has priority, i.e. if a log-in
is recorded at an "Extra" terminal and its relative ATMO expires, log-out occurs
automatically.
If an "Extra" terminal's parameter ATMO=0 (unlimited access time) a user must log-out
directly at such a terminal with "BYE".
Selecting "Extra" Device(s) makes sense if there are several operating terminals in the
same room and saves a user entering his password at each terminal separately in order
to operate the VISONIK DCS system.
At this point the operator who is generating the new key can enter a password for the
named user.
A password must contain
between 3 and 7 characters
and is terminated
with <CR>. There is no echo to a password entry.
Operating Range
Working Language
Extra Device(s)
New Password