User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-170 Function KEY Landis & Staefa Division
RECOMMENDATION
At any time a user can change his own password without using Function KEY.
This is carried out by entering a question mark "?" directly after logging on with the
current password. This question mark is terminated with <CR> and a new password
may be specified (without echo).
User Code: JB
Password: Alpha? <--These characters are not
echoed on the screen!
New Password: BeTa
Check Password: BeTa
If a password does not meet the system conditions then the text "Illegal Password
defined" appears in the listing of "KEY" entries.
This is for checking the above mentioned new password by repeating it and terminating
with <CR>. If the repeated "Check Password" is not the same, VISONIK DCS requests
a new password. If the repetition is in order the system responds with "ok!".
2.1.2.2 Change Data Entry
The authorised user may change any "KEY" entry whose Function level is equal to, or
less than, his own Function level.
To change a "KEY" entry the user must enter the relative User Code. For checking
purposes, VISONIK DCS outputs a complete listing of this KEY entry. The user is in a
change mode in which the entry can be either deleted or each entry section may be
changed, or confirmed, in steps.
A "KEY" entry is then changed whenever any one of these steps is terminated by <CR>.
The operator need not continue to the entry end but can conclude the dialogue with
Ctrl/E.
Operation=CH :
User Code: JB
John Brown /JB
Function Level = 4
Parameter Level = 3
Operating Range = Local
Working Language = 1
Address Range = a01'b*'**
Flag Address = $FL77
Active Devices = .
Extra Device(s) = T3&T4
Created by = L&G System Manager
Date of Entry = 05-Dec-95
Last Access = 12-Dec-95 / 15-Dec-95
Expiry Date = 31-Dec-99
Delete Key after expiry
User Name=John Brown: _
User Code=JB:
Expiry Date=31-Dec-99:
Delete Key after expiry=Yes :
.
.
Check Password