User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function KEY 2-171
The access authority of a user who is currently operating on the system cannot be
changed and on listing the associated entry the following message is output. Only the
specified language, the "Extra Device(s)" and password can be redefined:
13:49:12 ?Operator using System T1
Such a changed entry is only valid after the related active user is logged out from the
System (either with Function BYE or timeout of ATMO).
To change other entries the related named user must be logged out from the operating
terminal. If this is not possible, for example, if the terminal is faulty the terminal must be
set to Out of Service with OSV=YES.
2.1.3 LI, List Data Registers
Operation LI allows a User to list all "KEY" entries. By specifying one of the (*/%) masks
against "User Name (*/%):" a selective listing of "KEY" entries can be obtained.
Operation=LI :
User Name (*/%): Jo*
John Brown /JB
Function Level = 4
Parameter Level = 3
Operating Range = Local
Working Language = 1
Address Range = a01'b*'**
Flag Address = $FL77
Active Devices = .
Extra Device(s) = T3&T4
Created by = L&G System Manager
Date of Entry = 05-Dec-95
Last Access = 12-Dec-95 / 15-Dec-95
Expiry Date = 31-Dec-99
Delete Key after expiry
Operation=LI :
Input of "J*" provides a listing of all KEY entries which begin with "J".
The form of such a listing is the same as "KEY,CH".
2.1.4 Delete Register Entry(ies)
An authorised user may delete any "KEY" entry whose Function level is equal to, or less
than, his own Function level.
To delete a "KEY" entry the operator must enter the relative 'User Code'
(his own code is not accepted - "?Operator using System").
For checking purposes, VISONIK DCS outputs a complete listing of this entry on the
operating terminal. On answering the prompt "Delete Entry" with YES the entry is
deleted.