User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-220 Function PNT Landis & Staefa Division
Legend:
This represents a range of addresses to which the current operator has access.
A00'A1'22"AAAA
Point selection through User Address. On input of "*", the first address in the system is
prompted according to alphabetical structure.
$eee'mop, $Rn, $S, $Tn, ...
Technical Address selection.
Next UA/TA
By entering a "+" the next User or Technical Address can be called up in ascending
alphabetical order.
Previous UA/TA
By entering a "-" the previous User or Technical address can be called up in descending
alphabetical order.
2.24.2 Parameter selection
A particular parameter can be selected at the parameter prompt, provided the user's
read or write privilege is sufficient.
The VISONIK DCS then opens the parameter, allowing the user read or write access to
it.
All parameters can be displayed one at a time in alphabetical order by pressing the
<Enter> key, and each can be modified as appropriate.
In the case of indexed parameters, non-indexed parameter operation can be reactivated
by entering
'<'
.
2.24.3 Listing parameters
When a point address has been selected, the VISONIK DCS outputs a full message line
which contains the point's current status and gives a prompt for selection of the point's
main value.
In order to obtain an overview of the respective parameters, the possibilities described
in the following are available at this stage.
When "?" is entered, the VISONIK DCS produces a complete list of the abbreviated
parameter names in alphabetical order and sorted according to the four parameter
categories:
–
MAIN parameters
–
OPERATING parameters
–
CONFIGURATION parameters
–
SERVICE parameters
Operator's Address
Range = *01'**'**"****
UA
TA
+
-
Parameter
Control character <
Parameter listing with
"?"