User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-226 Function PNX Landis & Staefa Division
Parameter Value = 0:
2. Masking Param.=.: MSGP
Parameter Value = 1: 2
3. Masking Param.=.:
1. Operating Param.=.: ?
Parameters allowed: All
1. Operating Param.=.: OSV
Operating Mode=CHA: ?
0 LIST = List Parameter
1 CHA = Change Parameter (Fixed Value)
2 CHP = Change Parameter(Point by Point)
3 INSP = Inspect before Parameter Change
4 RPDV = Param. Change Messages (MSGDEV))
5 RPCH = Parameter Change Messages (DEVPCH)
6 LICR = CRLF before Listing Parameter
7 LISE = Printout with Separator
Operating Mode=CHA: LIST
2. Operating Param.=.: MSGP
Operating Mode=LIST:
3. Operating Param.=.:
with Status Rpt.=No : Yes
with Statistics=Yes :
PNX 15:23:05 Start of D A T A-L I S T 26.07.1996/Fr T8
Explanation of the previous example
Input of the first address range (user or technical address) to be referenced by the
function PNX. An individual address may be entered.
Up to 7
further addresses or address ranges can be defined at this level.
Masking parameters represent the boundary conditions that must be met by the points
and point ranges defined above in order for the desired parameters to be changed.
Masking parameters may be linked as required with AND statements or OR statements.
Permissible values for the parameter specified above. In the example: OSV=0.
Instead of a fixed parameter value, range definitions and comparison operators as per
the following table are permissible:
General: Operation and Value or Only Value
Operations for Numerical Values (x,y):
x(..y) Equals x or within x..y (default)
<>x(..y) Does not equal x or outside x..y
>x, >=x Greater than x, Greater than or equal to x
<x, <=x Less than x, Less than or equal to x
Operations for Bitset Values (x,y):
x&y Equal - Only Bit x,y set (default)
<> x&y Unequal - Only Bit x,y not set
and x&y AND Expression - Bit x and y set
or x&y OR Expression - Bit x or y set
not x&y Inversion - Bit x,y not set
A total of
up to 8
masking parameters can be defined at this level.
Definition of parameter to be changed or reported.
Up to 10
operating parameters can be specified at this level for change or reporting.
1. Address Mask
n. Address Mask
1. Masking Param.
Parameter Value
n. Masking Param.
1. Operating Param.
n. Parameter