User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-242 Function PRR Landis & Staefa Division
2.26.6 LOCT, List Reaction Entries in Octal
The LOCT operation can be used to selectively list the reaction entries according to the
same criteria as the LI operation. The normal list is followed by a printout of the same
data in octal code.
T8 12:17:08 Function=PNT : PRR
Operation =CH : LOCT
Reason =.. : ?
Reason =(UA,TA,...,..,*)
UA = AA'AA'A111"dd
TA = $sss'mm'p, $sss'CTYPn, $CTYPn, $sssMxxPyy
... = digitwise range
.. = range
* = all points with UA, $*=all points
, .. : $*
Entry =* : ?
Entry =* , (1..255): *
Reaction =.. : ?
UA/TA = Change Point Parameter
CT = Printout Cleartext
MC = Issue MACRO Command
SLVM = Output Slave Message
CB = Start/Stop COLBAS Task
. = No Reaction (for MRR & GRR)
PICT = Auto Picture/Point Selection
Reaction =.. :
PRR 12:17:52 Start of D A T A - L I S T 30.07.1996/Tu
T8
AI $100'001 = RO'OM'TEMP"01 / 4
Positive Edge 1: Normal ---> >HIL=22.0
Blocking Flag $FL10
.
?FL_____PRR Blocked!________($FL10.RFL=Off)
Reaction PACH_Change Point Parameter
Address DO $d100'041
Parameter DO__________Set Digital Output:
Priority=0
Value 0=Off
Reporting MSGDEV M1
DSW/Offset = REA. 3 / 332
0/ 100 76 404 25000 10144 4 12 2
20/ 4 41160 41260 41601 131463 0 1400 100000
40/ 41 62052 1622 0 0 0 0 0
60/ 0 0 0 0 0 0 0 0
PRR 12:18:01 End of D A T A - L I S T 30.07.1996/Tu
The list may be required by Landis & Staefa for diagnostic purposes.