User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-256 Function RPT Landis & Staefa Division
Point type 'M' Main value 'S' Status 'I' Additional
information
Analogue Input
For TYPE=AI:
AI TXU (ERSTA<>0 | OPSTA<>0) {OPMO}
Analogue Output
For TYPE=AO:
AO TXU (ERSTA<>0 | OPSTA<>0) {OPMO}
Counter Input
For TYP=CI:
CI TXU (ERSTA<>0 | OPSTA<>0) {OPMO}
Digital Input
For TYP=DI:
DI=(TXU) (ERSTA<>0 | OPSTA<>0) {OPMO}
Digital Output
For TYPE=DO:
or:
DO=(TXU) "("
Prio
")"
FBV=(TXU) "("
Prio
")"
(ERSTA<>0 | OPSTA<>0)
(ERSTA<>0 | OPSTA<>0)
{OPMO}
Point type 'M' Main value 'S' Status 'I' Additional
information
Virtual point
For TYPE=VIP:
VIP TXU (ERSTA<>0 | OPSTA<>0) {OPMO}
Plant point
For TYPE=PLT:
PSTA=(TXU) WHY CPRI (ERSTA<>0 | OPSTA<>0) {OPMO}
Regulator block
For TYPE=RGB:
PRV TXU {OPMO}
OSTP Zone (BPS)
For CTYP=ZON:
ZOSTA {TI "°C"} (ERSTA<>0 | OPSTA<>0) {OPMO}
Conversion param. Set
For TYPE=CVP:
"CS="CS "COF="COF "CNL="CNL {OPMO}
Point type 'M' Main value 'S' Status 'I' Additional
information
Process Station
For TYPE=PS:
PSST {"(" INR/ABO ")"} (ERSTA<>0 | OPSTA<>0) "Ri"PSRI "-"IDC
VERS
or:
VERS
1)
or:
"
"
"
"
"T"
TY#
"-"IDC
"K"
MC#
"/"
2)
Operating System
For TYPE=OS:
CB (ERSTA<>0 | OPSTA<>0) {OPMO}
Buildg Level Network
For TYPE=BLN:
INR AWAY {NOIS}
Process Bus
For TYPE=PBUS:
PBDIAG (ERSTA<>0 | OPSTA<>0) {OPMO}
Profibus Network
For TYPE=PBN:
NSTA (ERSTA<>0 | OPSTA<>0) {OPMO}
1)
TY# originates from the parameter LPS of the respective BLN point.
2)
MC# originates from the parameter MCAT of the respective BLN point.
I/O points
Function points
System points
Remarks: