User Manual

Siemens Building Technologies VISONIK DCS Functions and System Messages VVS18 CM2U8567E / 04.1999
Landis & Staefa Division Function RPT 2-265
The printout of a SYSR report can be flexibly controlled depending on the way in which
the system prompt "ADDRESS" is answered.
Address selection:
or:
*
$*
$xx
$xx..$yy
$Rx
$Rx..$Ry
$Tx $SY
Hardware, software yes -- -- -- yes
Shadow information yes -- -- -- yes
System loading yes -- -- -- yes
Reaction Registers yes -- -- -- yes
Teletypes all -- -- all --
Ring configuration all -- x -- all
Process stn descr. all x -- -- --
Description of the individual report sections
In this section the major data about the VISONIK computer (hardware) and the active
programs (software) are printed out:
Hardware-, Software Equipment:
==============================
CPU: 11M70
Memory: 1024 k mapped
@177546 Line clock, Frequency=50 Hz
@172152 DU
@172520 MM
VISONIK: PC050 v14.04.012
Project: Training Department
CPU: 11M70
Computer type (CPU) of the VISONIK DCS.
Memory: 1024 k mapped
Main memory size.
In the example the size of the main memory is 1024 kbytes. The computer has a
memory management unit (mapped).
@177546 Line clock, Frequency=50 Hz
@177546 is the hardware address of the line clock.
The line clock is the clock generator for the time on the DCS. The clock pulse depends
on the mains frequency.
At "BOO,I" the current mains frequency is determined to the nearest 0,1 Hz based on
the speed of the hard disk.
@172152 DU
Address and disk type (DU). This information describes the disk controller used. One
controller can control up to 4 disk drives.
@172520 MM
Hardware address of the memory management unit. This special logic extends the
maximum addressable range of the memory of PDP11 computers from 128 kbytes up to
4 Mbytes.
VISONIK: PC050 v14.04.012
Type and version of VISONIK software.
Project: Training Department
Project specific name of the DCS.
Hardware, Software
Equipment
Explanations: