User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-272 Function RPT Landis & Staefa Division
This section gives an overview of all configured data points that are not associated with
the I/O modules.
_____CTYP_______|_DCS____PS_____|_DCS-Number__________________
PBUS | 1 1 | 1
TTY | 3 3 | 1..3
RING | 1 1 | 1
PHON | 1 1 | 1
MC | 15 . | 1..15
SY | 1 . | 1
FL | 6 . | 10, 70, 74..77
RI | 6 . | 1..6
•
Point type
•
Number of configured data points in the DCS
•
Number of configured data points in the PS
•
Technical addresses of the data points configured in the DCS
–
as individual addresses, e.g, PLT13
–
as lists, e.g. AO3, AI27
–
as ranges, e.g. CVP1..CVP7
The information displayed in this section depends on the type of process station for
which the report is generated. This section partly supersedes other sections that are
described in the above.
This section is only displayed if a MONOGYR bus is configured.
_____MONOGYR_______|__________________________________________
MBUS: MBDIAG | 0=Error Free Transmission
MBINF : 23 RCE 2 SEZ
MBSTA : 3 : ???: No Answer
: 17 : RCE: Multiple Addresses Found
: 200 : ??? : No Answer
: 210 : ??? : No Answer
MGG1 : MGR# : 210 30 200 11 22 77 103 105 106 107
: 130 140 240
MGR210: RCE# : 210 30 200 11 22 77 103 105 106 107
SEZ# : 12 28 33
•
MBDIAG: Diagnostic information regarding the MONIGYR bus; see also parameter
MBDIAG.
•
MBINF: Total number of MONOGYR controllers and switch units connected to the
MONOGYR bus; see also parameter MBINF.
This line appears only if MBDIAG=0.
•
MBSTA: The address, type and clear text status (MBSTA) of a MONOGYR bus
device are shown on each line.
This line only appears if MBDIAG=0.
•
MGR#: List of all rooms that are allocated to a particular MONOGYR group.
•
RCE#: List of all controllers that are allocated to a particular MONOGYR room.
•
SEZ#: List of all switch units that are allocated to a particular MONOGYR room.
This section is only displayed if an ECU is configured.
________________________|_PS________________________________________
LPS=30 | 31: 43: 44: 48: 51: 52: 63:
ECU | 31 43 44 48 51 52
Configured data points
without I/O modules
Variable section
MONOGYR
ECU