User Manual

CM2U8567E / 04.1999 VISONIK DCS Functions and System Messages VVS18 Siemens Building Technologies
2-278 Function RPT Landis & Staefa Division
This line includes;
–
Time when "Comfort" level was reached.
–
Effective room temperature.
–
Room setpoint temperature.
This line includes;
–
Stop time at which the heating plant was switched off.
–
Room temperature at stop time.
–
Outside temperature at stop time.
2.28.17 DPR, Data Processing Tables/Graphs
Report type DPR provides an operator with a listing of values logged (recorded) in
DATA PROCESSING (DPO,GEN) in either tabular or graphic form. The output in
Function RPT,DPR is exactly the same as in function DPO.
The function, RPT, DPR provides the following possibilities:
T8 15:52:14 Function=PNT : RPT
Rpt.Type=SRPT : DPR
Format=GRAF : ?
0 GRAF = Graph
1 TAB = Table
Format=GRAF :
2.28.18 PLOT, Output Graph
A graph output instruction can be given in two ways:
•
In Function DPP by entering DPP,PLOT
•
In Function RPT by entering RPT,DPR
In both cases a report is started showing the report name DPR and is enclosed in the
typical "Report Start" and "Report End" lines.
If page formatting is active (parameter LPP of the relative terminal not set to 0) the
report starts on the next page.
After printing a graph the terminal remains in Graphics Mode until it is reset with <CR>,
<^P> or <^E>. If, after 5 minutes, no input has been given, the terminal automatically
returns to normal operation.
When two or more graphs are simultaneously requested on different terminals using
DPP,PLOT or RPT,DPR,GRAF a delayed graph output is given the message
"Bitmap busy! Please wait"
T5 10:17:04 Function=PNT : DPP
Operation=GCH : PL
Graph Number=10:
Output Device=$TT:
Bitmap busy! Please wait.
Line d)
Line e)
Parameter LPP
Terminal in graphics
mode
Output of several graphs
simultaneously